|   Home    |    About Us    |    Products    |    services    |  training  |   partners    |    clients    |    HSE    |   documentation   |    careers     |    Contact Us   |

   

 

Gem Traps

The energy efficient GEM® Traps have no moving parts and are backed by a 10 year performance guarantee. The GEM® Condensate Return System is the permanent solution to steam trap failure.

WHAT DO STEAM TRAPS DO?
The job of a steam trap is to trap, or hold, steam within the steam system while draining condensate out of it. It sounds simple, but a steam trap also has to:
• Vent air and non-condensable gases at start-up;
• Discharge large quantities of cold condensate as steam enters the system;
• Discharge much smaller amounts of hot condensate on
achieving temperature, and over varying conditions, without passing live steam.

WHAT MAKES GEM TRAPS DIFFERENT?
GEM Traps have a revolutionary venturi orifice design, which enables them to perform the job of a steam trap without the need for moving parts. This means that GEM Traps will not wear out and fail.


Advantages Of Gem Traps
• Increased production
• More control & heat output
• Enhanced safety and reduction on in Water hammer
• Ultimate reliability
• Minimal maintenance
• Permanent energy savings
• Short paybacks
• Superior product and service

Benefits of GEM® Traps
• Reduced maintenance
• No requirement for stocking spares
• Permanent energy savings (11 - 30%)
• Short payback (typically 12 - 18 months)
• Full sizing and commissioning support
• Complete turn-key solution available

 

 

         

OPAL STEAM TRAPS
For low load line drainage and trace heating lines (insulation bags available)
Operating Parameters:
PMA & PMO: 730 psi (50 bar)
TMA & TMO: 750°F (400°C)


Pipe Connections:
BSP/NPT/SW
1/2” - 3/4” (15 mm - 20 mm)
Flanged connections available


Material:
316L Stainless Steel
 

   
       

RUBY STEAM TRAPS

(Integral filter option for low duty applications)

Suitable for flanged applications

Operating Parameters:
PMA & PMO: 1450 psi (100 bar)
TMA & TMO: 935°F (500°C)

Pipe Connections:
1/2” - 4” (15 mm - 100 mm)
With optional filter: 1/2” - 1” (15 mm - 25 mm)

Flange rating:
Suitable for all standard flanges

Material:
303 Stainless Steel

 

 

 

   
       

TOPAZ STEAM TRAPS

For clean steam applications

Crevice free
Smooth internal surfaces to 32 μin (0.8 μm)*

Hygienic
Easy to clean and sterilize

Operating Parameters:

PMA & PMO: 145 psi (10 bar)
TMA & TMO: 392°F (200°C)

Pipe Connections:

1/2” - 1” (15 mm - 25 mm)

Material:

316 Stainless Steel

 

 

   
       

QUARTZ STEAM TRAPS

For low load drip leg and trace heating lines

Operating Parameters:
PMA & PMO: 720 psi (50 bar)
when gasket fitted to torque of 37 lb.ft (50 N.m)
TMA & TMO: 935°F (500°C

Pipe Connections:
BSP/NPT
1/2” - 3/4” (15 mm - 20 mm)

Material:
303 Stainless Steel

 

   
 
 
 

All Right Reserved. O-SECUL NIGERIA LIMITED. 2015